Before beginning the treatment, determine existing tooth shade withthe included Bleaching Shade Guide. Some teeth may be more heavilystained than others, so be sure to mark down "before" shade(s) to keeptrack of improvement.

1.Floss and brush teeth gently making sure not to irritate the gums. Rinse mouth with warm water.

2.Determine original tooth shade using the Bleaching Shade Guide.

3.Apply generous amount of lip balm to soften lips. Squeeze the armsof the cheek retractor together and insert it into the mouth with thetwo vertical slots facing outwards. Take care to ensure that the lipsare placed comfortably around the outside edge of the cheek retractorand that the lips are not touching the teeth. Bite down on the arms ofthe retractor. Apply more lip balm to the insides of the lips. If lipsare touching the surface of the teeth, place a piece of a cotton ballunder the lip to raise it off of the surface.

4.Use tissues, cotton balls, or gauze to dry the surface of the teethto be whitened. DO NOT apply the whitening gel to wet teeth.

5.Brush the whitening gel onto the surface of the teeth to bewhitened. Only a 2-3 mm layer of whitening gel is needed. Take care toensure that no gel comes into contact with the lips, face, gums, orhands. Remove excess gel with a dry cotton swab.

6.Open one of the whitening activator film packs. There are two filmsheets per pack, one for the upper teeth and one for the lower teeth.Remove the whitening activator film from the plastic backing and pressthe sticky side down onto the whitening gel-covered teeth.

7.Slide the e-Bright^™ LED cold-light unit into the fixed slots of the cheek retractor with the LED lights facing in towards the teeth.

8.Turn on the start switch on the battery pack to begin the firsttwenty-minute treatment. Turn off the unit when you hear the beepsignaling the end of the treatment time.

9.At the end of the twenty-minute, remove the e-Bright^™LED cold-light unit from the cheek retractor. Remove the whiteningactivator film from the teeth and throw away. Take out the cheekretractor and rinse mouth well with warm water.

10.Repeat the treatment an additional two to four times until desiredwhitening results are achieved. At the end of the total treatmentschedule, measure new tooth shade using the Bleaching Shade Guide.

The recommended initial treatment schedule is to use the e-Bright^™on three consecutive days for twenty minutes a day. If additionalwhitening results are desired, the treatment can be extended to five,twenty-minute treatments over five days.

Minimize consumption of colored food and drinks while using the e-Bright^™. Try to limit use of tobacco products. Maintain good oral hygiene during the treatment.

It is common to produce excess saliva during the first treatment asyou are not used to wearing the cheek retractor. It is safe to swallowyour saliva during the treatment and it may be helpful to lean your headback slightly to allow yourself to swallow the excess saliva asnecessary.

If the whitening gel comes into contact with the gums during thetreatment, the pink tissue may turn white during the treatment. Thiswill fade in a few hours following the treatment and is not cause forconcern.

If you have severe stains caused by tetracycline, fluoride, oranother chemical, discuss your best options for whitening these stainswith your dentist. The e-Bright^™ is effective on whiteningthese types of stains; however additional treatment cycles andadaptations may be necessary to achieve best results.

It is recommended that you contact your dental professional before beginning any new treatment.

Keep out of reach of children. Not suitable for pregnant or lactating women or children under sixteen years of age.